HomeProducts
Waterjet cuttingAutomation & Alu-profilesLaser equipmentMeasurement
NewsTradeshowsUsed equipmentAbout QteCLinksContactFind us
General Purpose
Hydro Cleaning Stop/PusherCross - CuttingVacuum Holding
ProScale Model 150ProScale Model 180ProScale Model 250ProScale model 280ProScale Model 380ProScale Model 580
Quality control Woodworking ProductsInterfaces & Data Acquisition Digital ReadoutsNews
Multi-5The Multi-5 is a new AB axes cutting head rail system for retrofitting to existing pure waterjet machines to enable a 5 axes cutting function. Fitted with up to 6 cutting heads to give high productivity where 5 axes cutting is required. Also available as part of a new waterjet system from QteC.SteelWaveA new type of cutting plan designed to reduce, or as in most cases remove the necessity to use expensive underlay materials. With minimal backsplash from the individual exchangeable wave elements, productivity can also be increased by removing the need to continuously replace underlay material between cutting cycles.EasyCut-SQteC has developed a sliding tabel.
The EasyCut-S with a sliding tabel is available
in sizes up to 1500 x 2000 mm.
New Business partnerQteC are working together with Dannozzle and are pleased to offer a new range of nozzles for hydro cleaning.
Dannozzle are specialists in the developement of nozzles for cleaning of evapourators and heat exchangers. Dannozzle has developed a unique nozzle that removes hard deposit in pipes with a much lower pressure than seen before.
Waterjet machinesQteC offer a wide selection of different waterjet machines, in all sizes, to meet the customers demands.
Spare parts and ServiceQteC offer spare and consumable parts as well as service and maintenance of almost every high pressure pump manufacturer on the market.
New homepageOur new homepage is now up and running.
It's now possible to receive our news letter. |
Waterjet Cutting
QteC offers everything for WaterJet cutting, click on one of the links below for more information.
The essence of waterjet is a high pressure intensifier pump. The Intensifier in such a pump increases the cutting water pressure up to a maximum of 6000 bar (90000 psi).
The combination of the high pressure and small jet, typically 0.08 to 0.35 mm. The water is accelerated to a speed of 750 to 1000 m/sec. Because of the pressure and speed it is possible to cut in almost all materials such as rubber, foam, paper, carpet, plastics etc. These soft materials are cut with pure water. With harder materials, such as glass, copper, aluminum, stainless steel, concrete etc. it is necessary to add an abrasive medium, typically Garnet sand. There by the sand grinds/cuts its way through the material. This Technology opens the way for many new possibilties for material choices, design and not least flexibility and efficient production.
|
|
Plastic
All grades of steel
Insulation
Rubber
Aluminum |
|
Gain an insight into how waterjet works and what advantages there are by choosing waterjet, by following the link below to WARDJet's "Waterjet University"
|
A guideline for cutting speeds for a selection of different materials and thicknesses, see the chart here.
 Below is a small selection of materials that are typically cut with waterjet. Contact QteC to arrange a test cut of your material. |
 |
